1756-rm2

kardel.sharpeye

Member
K
Join Date
Mar 2012
Location
Jakarta
Posts
29
Hello Guys,

I had a problem with 1756-RM2/A.
In my RS Linx (ver 3.51) It is shown as a mark question with red X sign that keep showing on and off. (pls see attachment)

When i connect another laptop (RS Link 2.59), it has no x sign at all.

Is there any problem in RS link 3.51? Should I update it to 3.60?
Is it possible to update firmware if the module still has x sign ?


Thanks in advance

Kardel

RS Link 1.jpg RS Link 2.jpg
 

Similar Topics

Q
1756/RM2/A Redundancy Module Synchronization Issue
Hi All, I am trying to synch the primary with secondary, which apparently was disqualified due to Watchdog error. I am getting the following...
Replies
0
Views
928
QasimFSH
Q
A
ControlLogix 1756-RM2/A problem
Dear Colleagues, Now I'm testing Rockwell-based control system that has been stored for 8 years. Have some major issue, that have not met before...
Replies
0
Views
1,188
ANR
A
M
1756-RM2 Redundancy DISQ
Hi , i have problem to configure redundancy of two plc , i have set into both plc the redundancy function and now i have PLC 1 with PRIMARY and...
Replies
2
Views
4,213
MichaelP_123
M
A
1756-RM2/A Redundancy Module Disqualified (at times)
Hello, My 1756-RM2/A Redundancy Module keeps entering the Disqualified module for half an hour or so, and then switches to Synchronized for like...
Replies
4
Views
6,476
p_logix
P
K
1756-RM2 compatibility
Hi Guys, Which version of RMCT that compatible with 1756-RM2 ver 20.017? I had RMCT ver 8.2.1.0 but when i try to configure 1756-RM2 there is a...
Replies
9
Views
9,474
tamilaotc
T
Back
Top Bottom