John Morris
Lifetime Supporting Member
Morning all,
I am modulating two different item in this set up.
One will accept an external source 0-5. (Chnl1)
The other is an Eaton DE1 VFD which, I am reading, requires it's own source (0-10v) for modulated control.
Is there a way to get the 10 volt signal thru the analog module?
I have read the analog modules 1769-um002, the I/O modules specifications 1769-td006, and Publication 1769-IN049A-EN-P for reference
and found only this "Voltage outputs (Vout 0+ and Vout 1+) of the 1769-OF2 module are referenced to ANLG COM. Load resistance for a voltage output channel must be equal to or greater than 1K Ω ."
I "assume" this is the input for the Eaton 10v. Could anyone confirm please
PLC L33, module is 16th and fourth from the PA4
Thank you for your time and attention.
Last edited: