My 1769-SDN rev 4 is seemingly stuck in idle mode. I have the configuration all set up correctly as far as I can tell. The card is in slot 1, and it's the only card in the chassis. I see all my scan nodes when I'm online in Networx, I have no error codes (just flashing node number 00 to 80 and back) on the scanner, if I pull the plug out on the scanner I get all the node numbers flashing for dropping the signal, everything seems copacetic.
If I jump online to my PLC (CompactLogix L33-ER rev 24) and activate my Slot 1 Word 0 Bit 0 to activate the scanner... nothing. Stays flashing 00-80. I have my distributor coming out in the morning to get some eyes on it, and Rockwell was no help (basically just kept telling me I needed to activate the run bit). Has anyone ever experienced this issue?
Thanks in advance!
If I jump online to my PLC (CompactLogix L33-ER rev 24) and activate my Slot 1 Word 0 Bit 0 to activate the scanner... nothing. Stays flashing 00-80. I have my distributor coming out in the morning to get some eyes on it, and Rockwell was no help (basically just kept telling me I needed to activate the run bit). Has anyone ever experienced this issue?
Thanks in advance!