the44
Member
I have a tonnage monitor module hooked up to an analog card using a plc 5-30.
Analog Card is a 1771 IFE/C. We had the OEM visit to do calibration on the tonnage module, And found that we cannot display anything in the 700 range.
for example while tweaking the calibration pods slightly after getting a reading in the high 600 range tonnage display would jump to a value in the 800's. No matter what we did we couldnt get readings in the 700 range. The display is done via block transfer and displayed on a pv 1000e. The tech said there isnt an issue with the tonnage module as it dispalyed 700's with the unit he was using to calibrate with. just wont show 700 range when going through my analog card.
I am not an expert on these cards, So I was wondering if anyone here might have an idea as to why I might be having this issue. Must be the ife/c card but not sure why. Thanks in advance for any information
Analog Card is a 1771 IFE/C. We had the OEM visit to do calibration on the tonnage module, And found that we cannot display anything in the 700 range.
for example while tweaking the calibration pods slightly after getting a reading in the high 600 range tonnage display would jump to a value in the 800's. No matter what we did we couldnt get readings in the 700 range. The display is done via block transfer and displayed on a pv 1000e. The tech said there isnt an issue with the tonnage module as it dispalyed 700's with the unit he was using to calibrate with. just wont show 700 range when going through my analog card.
I am not an expert on these cards, So I was wondering if anyone here might have an idea as to why I might be having this issue. Must be the ife/c card but not sure why. Thanks in advance for any information