Hi All
I installed a 1794-aent/b ethernet/ip module today. Rslinx dont recognize it. Only when I set the communication driver as a ethernet device
then I get the ip displayed(rslinx) and a yellow question mark. I tried two different modules same firmware. All the other modules on network display
correctly.
I used bootp to set the ip. Then went to rslinx to see if module detected, but nothing(already a existing network).I can ping the module though.
Is there any compatibility issues with the software that I use?
Module firmware :4.3
Rslinx clasic: 2.5.....
RSlogix 5000 : 19.01.01
Win7 OS.
I've setup up some of these modules before(firmware version 4.1-4.2) no problem.
I realy would appreciate any help.
regards
I installed a 1794-aent/b ethernet/ip module today. Rslinx dont recognize it. Only when I set the communication driver as a ethernet device
then I get the ip displayed(rslinx) and a yellow question mark. I tried two different modules same firmware. All the other modules on network display
correctly.
I used bootp to set the ip. Then went to rslinx to see if module detected, but nothing(already a existing network).I can ping the module though.
Is there any compatibility issues with the software that I use?
Module firmware :4.3
Rslinx clasic: 2.5.....
RSlogix 5000 : 19.01.01
Win7 OS.
I've setup up some of these modules before(firmware version 4.1-4.2) no problem.
I realy would appreciate any help.
regards