Hello everyone,
I have a little problem converting a 4-20ma signal to display a temp, reading on a PanelView.
I have a RTD wired into a temprature transmitter that is wired into a AB 1746 N1041 analog input/output card.
The instruction i am using is a SCP instruction (RSLogix 500)
All we want to know is if the tank we are trying to read is freezing or not.
So, does anyone have an idea on how to set up the SCP instruction w/ out producing a 4ma and a 20ma to produce raw data for the input min.and input max,for I dont have the means to produce the signal.
Thanks again all
I have a little problem converting a 4-20ma signal to display a temp, reading on a PanelView.
I have a RTD wired into a temprature transmitter that is wired into a AB 1746 N1041 analog input/output card.
The instruction i am using is a SCP instruction (RSLogix 500)
All we want to know is if the tank we are trying to read is freezing or not.
So, does anyone have an idea on how to set up the SCP instruction w/ out producing a 4ma and a 20ma to produce raw data for the input min.and input max,for I dont have the means to produce the signal.
Thanks again all