Is RSLinx able to communicate with the controller? What is your baud rate? The AUTO baud rate does not cover every possible baud rate, just the ones used 99% of the time.Thanks tried both, im most likely missing something very obvious,
I posted a few screen shots just in case
...Some simple tests with a CompactLogix L35E has shown a 1000 DINT tag read completes in 44ms.
The latest version I have deployed apps against is version 20. I don't have any setup to test the newer version with. I'm not sure if other users are running later than version 20 with AdvancedhMI, but I have not had any reports of problems.Just curious, how good is your driver with v21+ firmware and complex nested UDT's? The v21 changes seemed to cause havoc with everyone except Kepware since I believe they worked directly w/Rockwell on it.
The latest version I have deployed apps against is version 20. I don't have any setup to test the newer version with. I'm not sure if other users are running later than version 20 with AdvancedhMI, but I have not had any reports of problems.
Do you mean Visual Studio 2010?
Interesting, I did not know that was possible. I have only ever used Visio to draw flow charts. How do you get a Visio document to be active and communicate with a PLC?
I think I am completely misunderstanding where Visio is coming into play.Ooops, sorry for the misunderstanding. I was asking if it is possible to run this with Visio 2010. I am at the MSDN website and searching for the program you reference in the video.
I think I am completely misunderstanding where Visio is coming into play.
Are you looking for Visual Studio on MSDN? If so, this is the latest version:
https://www.visualstudio.com/en-us/products/visual-studio-community-vs
Are you looking for Visual Studio on MSDN? If so, this is the latest version:
https://www.visualstudio.com/en-us/products/visual-studio-community-vs
I did notice your ComComponent was DF1Com4, which means that 4 drivers must have been added to the form. Below the form, check to make sure DF1Com4 is the only item there. If so, select it and check to make sure the right COM port is set.Hello again. I think I am following the instructions on the .pdf but am getting no results. I attached a couple screenshots to see if I am doing something wrong. The one shows what my .zip file contains because it doesn't have the file you speak of in the video. Thank you.