Nan
Member
Hi All, I am having an odd issue, need help now!
The studio version is 32.13, drive add on is 5.08.
PLC is l36erms, the 755 drive is standard + safety, it was working until I change processor IP address.
After I change PLC ip address, there is yellow mark on the drive under device tree, I think it was caused by the ownership, it has to be reset.
However, when i trying to reset the ownership, right click the drive-property, the property page opens, then the mouse is just keep circling, it frezzed.
What do I need to do? Sould I recreate the 755 in the project or reset the 755 to factory default? How should I reset to factory default?
Thank you!
The studio version is 32.13, drive add on is 5.08.
PLC is l36erms, the 755 drive is standard + safety, it was working until I change processor IP address.
After I change PLC ip address, there is yellow mark on the drive under device tree, I think it was caused by the ownership, it has to be reset.
However, when i trying to reset the ownership, right click the drive-property, the property page opens, then the mouse is just keep circling, it frezzed.
What do I need to do? Sould I recreate the 755 in the project or reset the 755 to factory default? How should I reset to factory default?
Thank you!