ABB IRC 5 Status bits to ControlLogix

Scottwalth67

Member
S
Join Date
Apr 2017
Location
Chattanooga TN
Posts
1
Hello all, I am fairly new to ABB Robotics (FlexPicker) and have been asked to see if there is a way to get status bits to a ControlLogix PLC. Reading some articles I see a Ethernet card can be placed in the ABB IRC 5 panel and ran to the PLC to an Ethernet card there. The PLC is not a problem, well, setting up the actual comms may be challenging but that why we all playing with this stuff! Anyway, the information being reqested from the ABB is idle time, faults, run time, etc. Has anyone played with this or know if this is doable? Any info would be appreciated. o_O
 

Similar Topics

T
ABB PM554-T
Quick question: Can PLC ABB PM554-T generate PWM/PTO for controlling servo drive? Can not find manual file.
Replies
1
Views
56
DarrylR
D
R
Unable to import capability file for FF device in ABB Freelance engineering tool
Recently we have purchased the Rosemount 752 remote indicator to replace with new one, Capability file for that FF Device is unable to import with...
Replies
0
Views
51
Rehanuldhanveer
R
EICS
ABB PS501 Control Builder Plus V2.3 Install - anyone use it or know of it
does anyone have an install or know if/where i can download it for the following "ABB PS501 Control Builder Plus V2.3 " the software was a free...
Replies
2
Views
140
ojz0r
O
S
IE5 ABB motor and VFD
Hello, It is mandatory to use VFD IF i use IE5 electrical motor? What happens If connect it directly as delta without VFD? Please look at motor...
Replies
1
Views
188
kamenges
K
R
ABB ACS800-07 VSD fault on ramp up between 98 and 100%
Hi hoping someone can assist me with current issue I am experiencing with an ABB drive. Problem I’m experiencing is a ABB drive supply a large...
Replies
4
Views
252
BryanG
B
Back
Top Bottom