psychosunshine
Member
I'm adding an IAI Gateway with 2 axes connected to it. To an ethernet network on my PLC.
So, I think the math is correct on the Input and Output sizes. But, this module is faulted.
I tried others sizes of 16, 32, etc. None worked.
The gateway counts at 8, and each axis is also 8. So, that's 24. The manual says to use 100 and 150, as shown. And, DATA - INT for the Comm Format.
Any ideas?
So, I think the math is correct on the Input and Output sizes. But, this module is faulted.
I tried others sizes of 16, 32, etc. None worked.
The gateway counts at 8, and each axis is also 8. So, that's 24. The manual says to use 100 and 150, as shown. And, DATA - INT for the Comm Format.
Any ideas?