Hi,
I have an issue with communication settings between an Allen Bradley ControlLogix PLC and IDEC Touchscreen via Ethernet/IP. Below are the components:
Allen Bradley 1756-L61 ControlLogix 5561 Controller (Rev 17.2)
Allen Bradley 1756-ENBT/A 10/100Mbps Ethernet Bridge (Rev 4.1)
IDEC HMI HG3F-FT22TF-*
The error message on the HMI is:
"Host Communication err
Error Station No:00h"
I am following the IDEC manual:
http://www.idec.com/language/english/AppNotes/ABControlLogixApplicationNotes.pdf
Has anybody had success with this before?
Any help would be greatly appreciated. Thanks!
I have an issue with communication settings between an Allen Bradley ControlLogix PLC and IDEC Touchscreen via Ethernet/IP. Below are the components:
Allen Bradley 1756-L61 ControlLogix 5561 Controller (Rev 17.2)
Allen Bradley 1756-ENBT/A 10/100Mbps Ethernet Bridge (Rev 4.1)
IDEC HMI HG3F-FT22TF-*
The error message on the HMI is:
"Host Communication err
Error Station No:00h"
I am following the IDEC manual:
http://www.idec.com/language/english/AppNotes/ABControlLogixApplicationNotes.pdf
Has anybody had success with this before?
Any help would be greatly appreciated. Thanks!