Hi all,
I’ve been asked about a project at work but given very little info. I’m somewhat experienced with Allen Bradley but far from an expert.
Basically I think they just want to add a floor scanner to the safety circuit and update the safety program to suit.
See images attached. I haven’t been to the customer site myself but I think they took an photo of the remote IO (point IO) and remote safety IO and I would need to find the PLC, is this correct? Would it be a ControlLogix?
Would I be using Studio 5000? Also don’t have much experience programming the Allen Bradley safety equipment. Do I do this through studio 5000 also when I get connected?
Any help greatly appreciated as always.
I’ve been asked about a project at work but given very little info. I’m somewhat experienced with Allen Bradley but far from an expert.
Basically I think they just want to add a floor scanner to the safety circuit and update the safety program to suit.
See images attached. I haven’t been to the customer site myself but I think they took an photo of the remote IO (point IO) and remote safety IO and I would need to find the PLC, is this correct? Would it be a ControlLogix?
Would I be using Studio 5000? Also don’t have much experience programming the Allen Bradley safety equipment. Do I do this through studio 5000 also when I get connected?
Any help greatly appreciated as always.