Oleksandr_Husyev
Member
Hello everybody!
One our customer from the far placed site sent us a video with the very strange behavior of SLC 5/03.
Link on this video:
https://drive.google.com/file/d/0B1cF3Af-O4PHaEFYVXVHT21KN00/view
After power on LEDs on the SLC CPU module every two seconds cyclically light in the following sequence:
1. FAULT, FORCE, DH485 - all are lighting for 1 second
then after 1 second:
2. FAULT, BATT, FORCE, DH485, RS232 - all are lighting for 1 second
then after 1 second everything repeats once again.
The customer also tried to reset this fault with key switch (RUN -> PROG -> RUN) but this had no effect. Also he doesn't have any software or cable to connect to the PLC and check out fault information with RSLogix. This is a stand alone far placed production line so we can't get there immediately.
What the kind of fault could it be?
Best regards, Oleksandr.
One our customer from the far placed site sent us a video with the very strange behavior of SLC 5/03.
Link on this video:
https://drive.google.com/file/d/0B1cF3Af-O4PHaEFYVXVHT21KN00/view
After power on LEDs on the SLC CPU module every two seconds cyclically light in the following sequence:
1. FAULT, FORCE, DH485 - all are lighting for 1 second
then after 1 second:
2. FAULT, BATT, FORCE, DH485, RS232 - all are lighting for 1 second
then after 1 second everything repeats once again.
The customer also tried to reset this fault with key switch (RUN -> PROG -> RUN) but this had no effect. Also he doesn't have any software or cable to connect to the PLC and check out fault information with RSLogix. This is a stand alone far placed production line so we can't get there immediately.
What the kind of fault could it be?
Best regards, Oleksandr.