Hope somebody can help with a problem I have with a leuze asi compact light beam, we have had one fail and did not have a replacement so I removed the light beam out of the asi mon software we use running on a leuze asm safety monitor connected to a Siemens step 7 300 plc asi module cp 342-2 master re taught the code sequence on the asm and all nice and happy ,we then received new light beam I addressed the beam using a leuze hand help programmer, connected it to the system reloaded the program into asm monitor with the light beam address in it but when trying to teach the code sequence it cannot find the address any ideas would be grateful .http://www.plctalk.net/qanda/images/smilies/confused.gif
ASI addressing help
- Thread starter adeguest
- Start date
Similar Topics
I want wnt to know about addressing of ASI slave module. If I enter addressing in slave configuration of ASI Master, the addresses it tatakes...
Where can i find a manual on this
3RK1904-1AC00
And which is more up to date, the above or
3RK1904-2AB01
I have very limited information on readdressing asi modules The information I have found states that you must readdress asi manually if you...
- Batchl3
- LIVE PLC Questions And Answers
Hello,
It's been a while since I posted a question on this forum.
We will convert iFM ASi gateway AC1308 (DeviceNet) into iFM ASi AC1424...
Hello all. I am trying to communicate to an ASi gateway from my CpLX (L16ER). I am able to ping the gateway and it replies. I configured the...