wim sidmar
Member
A beckhoff BK2000 lightbus card goes into I/O error. (red LED)
After a system reset the error is gone, but after some time it returns.
We replaced the BK2000 with a new card (BK2020).
The red LED was gone, but after a few seconds an other fault appears.
System manager => K-bus overrun ??
In the machine, there are more BK2000 cards.
We replaced our BK2020 card on a other place in the system with a BK2000.
The K-bus overrun error is gone.
BUT ! the red LED with I/O error appears again ????
does anyone has a idea or experiance ....
wim
After a system reset the error is gone, but after some time it returns.
We replaced the BK2000 with a new card (BK2020).
The red LED was gone, but after a few seconds an other fault appears.
System manager => K-bus overrun ??
In the machine, there are more BK2000 cards.
We replaced our BK2020 card on a other place in the system with a BK2000.
The K-bus overrun error is gone.
BUT ! the red LED with I/O error appears again ????
does anyone has a idea or experiance ....
wim