swphillips
Member
I'm working on an HMI running on a Beijer panel, and I'm trying to test out the project with the simulator in Information Designer. Does anyone know if it's even possible for the simulator to communicate with a PLC?
The setup seems fairly straightforward; I set the PLC's IP up in the controller 1 driver in the peripherals folder. However, the HMI shows no values from the PLC, and the PLC receives no commands or setpoints from the HMI.
The setup seems fairly straightforward; I set the PLC's IP up in the controller 1 driver in the peripherals folder. However, the HMI shows no values from the PLC, and the PLC receives no commands or setpoints from the HMI.