Hello everyone!
This is the first time I use Micro850 controller (2080-LC50-48QWB) and after I made a really simple programme (just for testing) I wanted to download it to my controller (which I was able to see and connect to via Ethernet and USB normally) and I got a message saying that firmware version didn't match (programme - v9, and PLC - v4).
So I found some datasheet where was explained how to upgrade device firmware with ControlFLASH. I started the mentioned software, choose the right controller, and I choose the version 9 and the process started, but near the end I got the ERROR message, and the update wasn't finished successfully. So my controller went to fault (FAULT red light flashes) and now I can not see it in RSLinx nor via Ethernet nor USB.
Does anyone have any idea what could I do to try to establish connection with my controller? I have tried to change from prog mode to run, and back to prog, but the fault remains.
I really hope that I didn't make some serious mistake, because we need this PLC very soon for work.
Thanks in advance!
This is the first time I use Micro850 controller (2080-LC50-48QWB) and after I made a really simple programme (just for testing) I wanted to download it to my controller (which I was able to see and connect to via Ethernet and USB normally) and I got a message saying that firmware version didn't match (programme - v9, and PLC - v4).
So I found some datasheet where was explained how to upgrade device firmware with ControlFLASH. I started the mentioned software, choose the right controller, and I choose the version 9 and the process started, but near the end I got the ERROR message, and the update wasn't finished successfully. So my controller went to fault (FAULT red light flashes) and now I can not see it in RSLinx nor via Ethernet nor USB.
Does anyone have any idea what could I do to try to establish connection with my controller? I have tried to change from prog mode to run, and back to prog, but the fault remains.
I really hope that I didn't make some serious mistake, because we need this PLC very soon for work.
Thanks in advance!