I have these PLC and HMI and want to communicate them. I made a program in RSLogix5000 and FactoryTalkViewStudio, tried them out with FT station and it worked well.
However, when I make the runtime application, a message appears stating:
*** Start RSLinx Enterprise Conversion Messages ***
WARNING: Unsupported device detected. Shortcut name = "L30ER". Device name = "Demo2". Description: The system has detected that a device type that was not supported in the requested version is referenced by a shortcut. If the system upon which this project is to be run has received a patch that adds support for this device type, then this situation will not cause any problems. Otherwise runtime errors will be detected and logged by the target system when it attempts to communicate to that device.
*** End RSLinx Enterprise Conversion Messages ***
Validation completed with warnings. The runtime application has been created.
CAUTION: Running this application might produce errors at runtime.
What I have came up with is that the PLC (Compactlogix rev 20) is a little to advanced for the obsolete HMI (PanelViewPlus1250 rev 5.10.06.09).
Is there a way to help this situation? or are these 2 hardwares simply just too far apart?
Thanks
However, when I make the runtime application, a message appears stating:
*** Start RSLinx Enterprise Conversion Messages ***
WARNING: Unsupported device detected. Shortcut name = "L30ER". Device name = "Demo2". Description: The system has detected that a device type that was not supported in the requested version is referenced by a shortcut. If the system upon which this project is to be run has received a patch that adds support for this device type, then this situation will not cause any problems. Otherwise runtime errors will be detected and logged by the target system when it attempts to communicate to that device.
*** End RSLinx Enterprise Conversion Messages ***
Validation completed with warnings. The runtime application has been created.
CAUTION: Running this application might produce errors at runtime.
What I have came up with is that the PLC (Compactlogix rev 20) is a little to advanced for the obsolete HMI (PanelViewPlus1250 rev 5.10.06.09).
Is there a way to help this situation? or are these 2 hardwares simply just too far apart?
Thanks