Hi all,
I have a CompactLogix L24ER QBFC18 with a built in high speed counter card and analogue I/O card.
I was using the 2 analogue outputs to control the speed and torque of a piece of equipment.
Through trouble shooting one night, 24VDC was mistakenly applied to one of the analogue outputs and caused a fault on the PLC.
When I cleared the fault, everything is back to normal, except that I am no longer getting my analogue outputs. (No voltage)
Is there anything that I can try?
If something is blown inside the PLC, can this be fixed or is it a lost cause?
Many thanks in advance for any and all help!
I have a CompactLogix L24ER QBFC18 with a built in high speed counter card and analogue I/O card.
I was using the 2 analogue outputs to control the speed and torque of a piece of equipment.
Through trouble shooting one night, 24VDC was mistakenly applied to one of the analogue outputs and caused a fault on the PLC.
When I cleared the fault, everything is back to normal, except that I am no longer getting my analogue outputs. (No voltage)
Is there anything that I can try?
If something is blown inside the PLC, can this be fixed or is it a lost cause?
Many thanks in advance for any and all help!