mjp123gp
Member
I'm trying to setup our Siemens PLC's so I can access them remotely via Ethernet but can't quite figure it out. I've got my PG setup and can see all the devices on the Accessible Nodes list. My issue is that I only see the Ethernet module in the rack. I can't get to the processor. See attached pic.
My setup chassis has a CPU 315-2 DP and the Ethernet module is a CP 343-1 IT on the opposite end of the chassis. How do I route through that Ethernet module to get to the CPU?
My setup chassis has a CPU 315-2 DP and the Ethernet module is a CP 343-1 IT on the opposite end of the chassis. How do I route through that Ethernet module to get to the CPU?