Connecting to a 5/03 and a 5/04.
- Thread starter HoldenC
- Start date
Rube
Member
Now Genius, that's some fine customer service!
geniusintraining
Lifetime Supporting Member + Moderator
Thank you!... I know its getting hard to find these days but I do care about my customers and try and do them right
Word Police!...
Mark,
Be careful with your choice of words! "do them" could be taken in a whole other light!
But bravo to you!
G.
geniusintraining said:Thank you!... I know its getting hard to find these days but I do care about my customers and try and do them right
Mark,
Be careful with your choice of words! "do them" could be taken in a whole other light!
But bravo to you!
G.
geniusintraining
Lifetime Supporting Member + Moderator
Hi George,
Parently you have not been to the 'south' much.... dats how we's speaks down heres, stick with me and i'll learn you somtin'
But thanks for trying to straight'n out this bent arrow
Mark
Rube
Member
Just a note...if you boys haven't dropped in on "GIT's" website lately--DO. I just did and it's a pirate ship worth of treasure compared to the last time I was there.
Last edited:
Similar Topics
Hello all --
I have a Fuji controller that has an ethernet card and am looking to translate the code to a GuardLogix 5380.
Any suggestions on how...
I have 2 PLCs. One is networked to our plant, and the other is networked to the first PLC via a 1756-EN2T.
I could easily get the second PLC...
Good Day to all of you, this is my first post, i will try to explain as best as possible, english is not my natural language. I am performing an...
I have been working on this for a while now and I can't seem to get it. I was finally able to view the 1500 on the PanelView under the serial...
Hello, I was looking to store some values from our FactoryTalk Application using Datalog to a MariaDB. I see there is quite a bit of documentation...
