geniusintraining
Lifetime Supporting Member + Moderator
Hello,
I have a new CLX, I powered it up downloaded the firmware, configured the I/O's, but I have two cards left a Enet and a DHRIO
Anyone have any procedures or links that they could point out
I have assigned a IP address to the module tried to configure linx but I dont think I did it correct (due to the fact it's not there, I used AB_ETHIP-1 and to top it all off my Linx help is not working
I have not tried the DHRIO yet, I hope I have better luck with that one
Thanks
I have a new CLX, I powered it up downloaded the firmware, configured the I/O's, but I have two cards left a Enet and a DHRIO
Anyone have any procedures or links that they could point out
I have assigned a IP address to the module tried to configure linx but I dont think I did it correct (due to the fact it's not there, I used AB_ETHIP-1 and to top it all off my Linx help is not working
I have not tried the DHRIO yet, I hope I have better luck with that one
Thanks