Control Net segment type in IOI invalid

fahadash

Member
F
Join Date
Aug 2009
Location
Boca Raton, FL
Posts
1
I am fairly new to RSLinx. I am getting the following error message every 10 seconds in "Communication events" dialog.
Control Net segment type in IOI invalid.
PLC's IP address and the item inside the PLC is mentioned.

My question is, for what reason this message comes up ?


Thanks,
Fahad
 
Hrm... That is coming up in RSLinx? ControlNet Segment Invalids are usually caused by a generic module with an invalid setup for INPUT | OUTPUT | CONFIGURATION, although it can also be caused by improperly adding HMI's to a network on the Logix Platform PLCs.

I'm sure there are other reasons, but I can't think of any.
 

Similar Topics

K
Mitsubishi F800 Control Via Ethernet IP
So the customer purchased a Mitsubishi drive, in the same project for a different pump they got an ABB drive, was literally whatever they could...
Replies
1
Views
80
kdean94
K
D
Lincoln Power Wave 455M Devicenet PLC control
Good day Forum Members I got a older Lincoln welder and hoping to make it work at our shop. Welder in question is the Lincoln Power Wave 455M...
Replies
4
Views
236
dextaca
D
P
PLC Ethernet or ENT2 Port for Machine Control
An outside contracting firm designed a machine for our company. There are several devices connected through Ethernet/IP. This includes a Panel...
Replies
4
Views
204
robertmee
R
R
rsnetworx for control net
I am getting random comm loss (error code 561 i think?) anyway i looked it up and its loss of comm to 2 modules on a controlnet network. The 2...
Replies
0
Views
366
RY_Guthrie
R
C
PF 525 Ethernet speed control
Hey everyone! I'm searching for an example demonstrating how to program in Studio 5000 speed control of a PowerFlex 525 drive via Ethernet. While...
Replies
1
Views
670
joseph_e2
J
Back
Top Bottom