Tim Ganz
Member
When building control panel and using sticky backs I normally drill through the little hole in the middle and tap it for a machine screw to make sure it never comes off but can't really do that on the panel door when using sticky backs to make all the pilot and push button wiring look nice.
We have a hot environment and I think these will pop off over a few years. I am using the Panduit tabs for wire ties that connect to the pilot devices like these http://www.panduit.com/heiler/CatalogCutSheets/CPM87S-C Product Page.pdf
But there are so many devices I still need to use a few stick backs. I have had people say that applying a little super glue to the outside edge helps? Any other tips for making sticky backs stay put?
We have a hot environment and I think these will pop off over a few years. I am using the Panduit tabs for wire ties that connect to the pilot devices like these http://www.panduit.com/heiler/CatalogCutSheets/CPM87S-C Product Page.pdf
But there are so many devices I still need to use a few stick backs. I have had people say that applying a little super glue to the outside edge helps? Any other tips for making sticky backs stay put?