Controller that operates below zero celsius

[klikopc]

Can you guys name me a couple of controllers that operate to about -20 Celsius?
I need one to work in outside conditions for the entire year!

which one would you recommend?

Matic

 

[blamb]

An insulated panel with a panel heater can be a good choice to keep any controller running through the cold winter months.

 

[klikopc]

That would work, but i need a guarantee that it will work at any time, even if power goes out for a day and the controller gets to below zero temperatures, like for example in a car. It has to start up without any problems once power comes back and is not yet heated enough!

 

[Bob K]

For what it is worth, take a look at Schneider Twido Extreme.

I never used them but the specs may meet you needs. Operation spec from -40C to 110C. It looks like it is made for heavy machinery / construction vehicle use so I do not know if it will work on your app. No idea how much this costs either.

I think one of the other EEs here was looking to use a small micro GE Fanuc once that supposedly had the op. specs down to -20C. I don't know what model # but it might be worth a look at their site.

 

[fryman]

Hi klikopc

Ab has a version of the controllogix pac's called XT that can be used down to -25C.
http://www.ab.com/en/epub/catalogs/12762/2181376/2416247/360807/1837516/tab4.html

its properly very expensive, but should do the trick

regards

 

[JRW]

Siemens has a Siplus line that will work

-25 to +60 C

 

[Djuro Emedji]

Ifm electronics has controllers for -40..85°C, not too expensive, programmable with CoDeSys.

 

[klikopc]

Thanks for the info guys!

Those are just what i'm looking for!!!!

 

[blamb]

Even though I hate to bring this up, I believe most SCADAPack's by Control Microsystems are rated down to -40.

 

[shooter]

i only use WAGO as they can run below zero they have DNV (marine) approval.

 

[MrQ]

And then there is always Sauer Danfoss Plus 1 that is designed for mobile applications. -40C is no problem.

http://www.sauer-danfoss.com/Produc...crocontroller/PLUS1Microcontrollers/index.htm


But since the programming software is expensive I would go for IFM:

http://www.ifm.com/ifmuk/web/pmain1!4_10.html

This is programmed in Codesys that is free!