Hello,
After a little help. We have ControlNet set up in redundancy - how do i show which channel is active in the PLC code? Can see all the info on the module pop up when removing cabels etc (channel A active, channel B standby), but can't find where to get that info to relay to the PanelView. Also can't seem to get the indication on what's happening when one of the cables is pulled out (it's actually all working OK, just need to display what's going on).
Any help appreciated.
Thanks,
Chrispie
After a little help. We have ControlNet set up in redundancy - how do i show which channel is active in the PLC code? Can see all the info on the module pop up when removing cabels etc (channel A active, channel B standby), but can't find where to get that info to relay to the PanelView. Also can't seem to get the indication on what's happening when one of the cables is pulled out (it's actually all working OK, just need to display what's going on).
Any help appreciated.
Thanks,
Chrispie