emjr93
Member
Hello all,
I am currently working on a small project for a conveyor system.
We have two different pack sizes (6 pack and 3 pack).
The program is set up for only one setting for motor speeds and photo eye delay timers.
Due to weight, some of the conveyor start delays and motor speeds need to be edited for the different pack size.
I'd like to save the settings operators enter for each within the program and have it change based on pack size selection, the code is as follows...
---------MOV
Source; Photo_EyeDelay[1]
Dest; Photo_EyeDelay1.PRE
The HMI writes directly to the source tag in the MOV function.
The PLC being used a CompactLogix.
I am currently working on a small project for a conveyor system.
We have two different pack sizes (6 pack and 3 pack).
The program is set up for only one setting for motor speeds and photo eye delay timers.
Due to weight, some of the conveyor start delays and motor speeds need to be edited for the different pack size.
I'd like to save the settings operators enter for each within the program and have it change based on pack size selection, the code is as follows...
---------MOV
Source; Photo_EyeDelay[1]
Dest; Photo_EyeDelay1.PRE
The HMI writes directly to the source tag in the MOV function.
The PLC being used a CompactLogix.