Platootod
Member
I met the problem when design the control cabinet
sometime does not match with the side of material
(the enclosure too small after installed the equipments )
Also, the standard to install plc inside the cabinet ...
Any book or webside that provide this information.
Or any good software that very usefull from your experience?
Thank you very much in advance.
sometime does not match with the side of material
(the enclosure too small after installed the equipments )
Also, the standard to install plc inside the cabinet ...
Any book or webside that provide this information.
Or any good software that very usefull from your experience?
Thank you very much in advance.