Good day all,
We are using a MicroLogix 1100 with a Panel View Component C600.
We are using a serial cable to communicate between the two and we get the following error:
"2: Data Access Error for Alias XXXX, Controller PLC-1, Address in XX:X, Communication Flag is 0"
Now, I've tried pretty much anything I can think of. Changing nodes, changing protocols, etc. And nothing gives.
I have a feeling I have the settings all wrong.
Did any of you have the same issue? I'm at a loss of how to fix this. This is a new installation, so it's not like the system worked before and now it doesn't.
Thanks in advance for any advice you can share.
Kindly,
Alan
We are using a MicroLogix 1100 with a Panel View Component C600.
We are using a serial cable to communicate between the two and we get the following error:
"2: Data Access Error for Alias XXXX, Controller PLC-1, Address in XX:X, Communication Flag is 0"
Now, I've tried pretty much anything I can think of. Changing nodes, changing protocols, etc. And nothing gives.
I have a feeling I have the settings all wrong.
Did any of you have the same issue? I'm at a loss of how to fix this. This is a new installation, so it's not like the system worked before and now it doesn't.
Thanks in advance for any advice you can share.
Kindly,
Alan