celichi
Lifetime Supporting Member
Hello Everyone!
I need to build / fabricate a stand that I will use at my desk.
The stand will hold a PanelView Plus 6 1000, PanelView 7 1000 and a smaller HMI, 4.3 inch.
I am considering different materials, plastic, wood (painted) or metal, but not sure which way to go.
I was wondering if anyone else here has undertaken a similar task, and if you did, what did you end up with?
I would basically like to have the HMI at 90 or a slight slope to avoid glare.
It doesn't need to have any Nema rating, as this is only for development and testing on my desk.
This is to avoid having to lean the HMI up against something and having it slide around when you are pushing on it.
Hoping for light and cheap.
I would be building this for myself, by myself.
Best regards,
Paul
I need to build / fabricate a stand that I will use at my desk.
The stand will hold a PanelView Plus 6 1000, PanelView 7 1000 and a smaller HMI, 4.3 inch.
I am considering different materials, plastic, wood (painted) or metal, but not sure which way to go.
I was wondering if anyone else here has undertaken a similar task, and if you did, what did you end up with?
I would basically like to have the HMI at 90 or a slight slope to avoid glare.
It doesn't need to have any Nema rating, as this is only for development and testing on my desk.
This is to avoid having to lean the HMI up against something and having it slide around when you are pushing on it.
Hoping for light and cheap.
I would be building this for myself, by myself.
Best regards,
Paul