urlauber1
Member
Hello all,
I have an Allen Bradley dh485 link coupler that I don't know how to test. I have a 1747 pic device but the driver is not supported using windows 2000 or higher. We are using a cuttler hammer 1570 pm panelmate connected to the dh485 link coupler. Then another link coupler to the dh485 connector on a slc 5/03.
The error message on the panelmate reads "LOC: 2200 on ?? via port 1 proc. data from 2 "
The original panel mate smoked and we installed a replacement that was pre programmed from the oem. Any thoughts on this appreciated
I am new to this site...hope this is the correct way to ask for help.
Thanks
dean
I have an Allen Bradley dh485 link coupler that I don't know how to test. I have a 1747 pic device but the driver is not supported using windows 2000 or higher. We are using a cuttler hammer 1570 pm panelmate connected to the dh485 link coupler. Then another link coupler to the dh485 connector on a slc 5/03.
The error message on the panelmate reads "LOC: 2200 on ?? via port 1 proc. data from 2 "
The original panel mate smoked and we installed a replacement that was pre programmed from the oem. Any thoughts on this appreciated
I am new to this site...hope this is the correct way to ask for help.
Thanks
dean