I have a SLC 5/03 and I connect vie 1747 UIC cable via ethernet plug in.
The panelview 600 PN is - 2711-T6C16L1 It is only TOUCH screen. I had an Error 31 earlier this morning and cleaned out the pv but some buttons are not working so I am needing to upload the program to my pc for when the new part arrives.
It uses a RS232 DHF1 connection to via serial cable to plug in the SLC.
Now when I am logged into Panel Builder 32 I can see the PV but I can never connect there is always a red X over it.
Also when I look in RSlinx I can see the pv also when I check to make sure my connection via the cable is working.
Recently I was able to download another PV program on a different machine but it was using DH+ connection at 57k baud.
Here a few pics of the SLC and PV..
The panelview 600 PN is - 2711-T6C16L1 It is only TOUCH screen. I had an Error 31 earlier this morning and cleaned out the pv but some buttons are not working so I am needing to upload the program to my pc for when the new part arrives.
It uses a RS232 DHF1 connection to via serial cable to plug in the SLC.
Now when I am logged into Panel Builder 32 I can see the PV but I can never connect there is always a red X over it.
Also when I look in RSlinx I can see the pv also when I check to make sure my connection via the cable is working.
Recently I was able to download another PV program on a different machine but it was using DH+ connection at 57k baud.
Here a few pics of the SLC and PV..
Last edited: