Young_Engineer
Member
Hey guys,
Recently I received the assignment to setup a ISH100... motor to a C200 motion controller. To enable the controller I would like to use standard I/O, however the C200 motion controller does not have I/O on board.
So the easiest way is to connect a PB DP Wago 750-333 I/O module to the C200. The communication to the motor and to the PB DP works perfectly, however...
It might be a bit complicated for a full Elau newbie like me to program the motion controller to let the motor turn both ways. So now I'm searching for newbie material to write the necessary program structure in EPAS-4.
Greetings,
Recently I received the assignment to setup a ISH100... motor to a C200 motion controller. To enable the controller I would like to use standard I/O, however the C200 motion controller does not have I/O on board.
So the easiest way is to connect a PB DP Wago 750-333 I/O module to the C200. The communication to the motor and to the PB DP works perfectly, however...
It might be a bit complicated for a full Elau newbie like me to program the motion controller to let the motor turn both ways. So now I'm searching for newbie material to write the necessary program structure in EPAS-4.
Greetings,