I have look at a few but that one looks very good, I also have taken a couple here in SC, one was at BMW, I did good on that one, the other one was for Michelin North America…I got my a$$ handed to me… and no I did not get the job...I will try again someday
28. A solid state device such as a PLC should never be used as a hammer (unless it make you mad)
No problem guys. I have used this test several times in the last year with good results. I usually allow an hour and a half to take the test in. So far only 2 out of 10 applicants have completed the entire test in the allotted time frame. It is a work in progress and I would welcome any comments or ideas for improvement.
Excellent test in my opinion. Although I am fairly new to this stuff I did get pretty much all of the PLC programmming and questions correct. My weak point is the electrical wireing and such.
This will provide me a good point to start studying up on what is deemed important. Thanks alot for taking the time to post this.