Hi All,
currently i am testing alarm behaviour of the new profibus slave device.For this purpose I am using 6ES7 151-8AB01-0AB0 CPU and DP Master(6ES7 138 -4HA00-0AB0) as Master along with Simatic manager( Step 7 v5.5+SP3) without wincc.
To monitor the frame messages I am using the Proficore ultra with Profitrace.
I would like to enable the alarms on PLC. Currently whenever I generate the diagnostics on the slave device. It is shown as diagnostic frame.
Can you please help me to enable alarms and alarms acknowledgement on s7300 while monitoring same on the Profitrace.
Thanks and regards,
shankar
currently i am testing alarm behaviour of the new profibus slave device.For this purpose I am using 6ES7 151-8AB01-0AB0 CPU and DP Master(6ES7 138 -4HA00-0AB0) as Master along with Simatic manager( Step 7 v5.5+SP3) without wincc.
To monitor the frame messages I am using the Proficore ultra with Profitrace.
I would like to enable the alarms on PLC. Currently whenever I generate the diagnostics on the slave device. It is shown as diagnostic frame.
Can you please help me to enable alarms and alarms acknowledgement on s7300 while monitoring same on the Profitrace.
Thanks and regards,
shankar