Error 8097: Controller Error - Configuration is not valid [0x05][0xE7]

azulaski

Member
Join Date
Apr 2022
Location
Houston
Posts
4
Hello,

I am having an issue downloading to a GE 90-30, CPU 364, I have configured the EGD following a documentation on GE Ethernet Global Data Driver Help. I updated the CPU firmware to 10.75 and I keep getting an error and code would not download. Can someone tell me what I could be doing wrong?

Error 8097: Controller Error - Configuration is not valid [0x05][0xE7]

Error occurs right at Downloading: ETHERNET GLOBAL

I have attached the code for reference, thank you very much.
 

Similar Topics

Error 8097: Controller Error - CPU slot mismatch [0x05][0x46] [0xC00C0001] I got that error above when I was trying to download my programming to...
Replies
2
Views
433
One of our customers had a Rx7i redundant Controller system for their plant. Due to some power failure the Controllers power was interrupted. Now...
Replies
1
Views
4,461
I’m getting this error: I’ve pulled the battery and left it out for a few minutes. It’s been a while since I’ve ran into this and I can’t...
Replies
1
Views
983
I am trying to download a program that will only change the integrated IP address in a rx3i IC695CPE305. The logic is equal. The current IP is...
Replies
9
Views
5,532
hello I have a HMI Cmt 2079x but when download my program this show me this mensage A critical error has ocurred. (id:3). Please contacter...
Replies
0
Views
44
Back
Top Bottom