Hello All,
I've been reading all over about exchange data from CPU315-2DP and IM151-8F CPU (ET-200s CPU).
End up what I just need to do for my application is nothing major, so I'll use:
CPU315-2DP with CP343-1 Lean (even though having only 4 connectivities and 8 S7-Connections available) it's plenty for what I need
IM151-8F CPU that will be connected straight to one of the CP343-1 lean ports.
I'll configure the FC "PUT" and "GET" only in the IM151-8F, and use the CPU315 as "serve".... just like the example shows:
https://support.automation.siemens....lib.csinfo&lang=en&objid=18610307&caller=view
Now... this is where I got stuck !
I configured the HW Config, and then when I went to the NetPro to make the S7-Connectio... I get the error that "No conectivity available..." (picture attached)!!!??!!
Do you guys have any idea what I missing out ???!!
Thanks in advance !!
PS.: I forgot to mention that both PLC's are in the same subnet mask (255.255.255.0) and their IP's are xx.xx.xx.05
xx.xx.xx.06
I've done AG_Send AG_Receive before, but as far as I know the IM151-8 isn't compatible, and the other solution would go to the TSEND and TRCV.... but seems like way to many configuration for the little that I need....
I've been reading all over about exchange data from CPU315-2DP and IM151-8F CPU (ET-200s CPU).
End up what I just need to do for my application is nothing major, so I'll use:
CPU315-2DP with CP343-1 Lean (even though having only 4 connectivities and 8 S7-Connections available) it's plenty for what I need
IM151-8F CPU that will be connected straight to one of the CP343-1 lean ports.
I'll configure the FC "PUT" and "GET" only in the IM151-8F, and use the CPU315 as "serve".... just like the example shows:
https://support.automation.siemens....lib.csinfo&lang=en&objid=18610307&caller=view
Now... this is where I got stuck !
I configured the HW Config, and then when I went to the NetPro to make the S7-Connectio... I get the error that "No conectivity available..." (picture attached)!!!??!!
Do you guys have any idea what I missing out ???!!
Thanks in advance !!
PS.: I forgot to mention that both PLC's are in the same subnet mask (255.255.255.0) and their IP's are xx.xx.xx.05
xx.xx.xx.06
I've done AG_Send AG_Receive before, but as far as I know the IM151-8 isn't compatible, and the other solution would go to the TSEND and TRCV.... but seems like way to many configuration for the little that I need....
Last edited: