Hi all,
1. I'm upgrading the pv550 to pv700+ and designing all the screen in Factory talk view ME edition. I got stuck at alarm setup. Because almost all my alarms are created in N7:1 (16 bit) (description as "alarm address array) and then N7:2 is used as (description as "reset alarm address array). So I went in Factory talk view and started creating new tags as mentioned below
Alarm1
digital
data source : device
address - "::[program]N7:0/1"
then went to alarm setup
selected trigger as alarm1
and trigger type as value
labeled "some message"
question 1. Do I have to use acknowledge bit N7:2 to reset alarm anywhere over here in optional trigger connections.
question 2. Can I used "::[program]N7:0/1" is this valid address or do I hve to use "::[program]N7:0 [L1]"
I have seen in some forum "::[program]N7:0 [L1]" someone was telling to use this.
can someone please help me in creating the alarms.
Your help is really really appreciated.
1. I'm upgrading the pv550 to pv700+ and designing all the screen in Factory talk view ME edition. I got stuck at alarm setup. Because almost all my alarms are created in N7:1 (16 bit) (description as "alarm address array) and then N7:2 is used as (description as "reset alarm address array). So I went in Factory talk view and started creating new tags as mentioned below
Alarm1
digital
data source : device
address - "::[program]N7:0/1"
then went to alarm setup
selected trigger as alarm1
and trigger type as value
labeled "some message"
question 1. Do I have to use acknowledge bit N7:2 to reset alarm anywhere over here in optional trigger connections.
question 2. Can I used "::[program]N7:0/1" is this valid address or do I hve to use "::[program]N7:0 [L1]"
I have seen in some forum "::[program]N7:0 [L1]" someone was telling to use this.
can someone please help me in creating the alarms.
Your help is really really appreciated.