I have a SLC 5/3 that is flashing a fault lite.
I have removed the battery and shorted the capacitor
I can communicate in RSLinx and it it will correctly read the I/O configuration in RSLogix 500
It displays messages that the processor is faulted and it show as faulted in Who Active..
Switch is in program
I have the jumper set to program
I have a small test program which I have used before.
I know I have to do a download ...but it always says Int driver failed code -1
I am using a 1747 UIC, which I just got, but it worked a few times
how can I get rid of the fault?
How does it correctly read the I/O config( I have removed and replaced output modules ) if it can't communicate?
thanks
I have removed the battery and shorted the capacitor
I can communicate in RSLinx and it it will correctly read the I/O configuration in RSLogix 500
It displays messages that the processor is faulted and it show as faulted in Who Active..
Switch is in program
I have the jumper set to program
I have a small test program which I have used before.
I know I have to do a download ...but it always says Int driver failed code -1
I am using a 1747 UIC, which I just got, but it worked a few times
how can I get rid of the fault?
How does it correctly read the I/O config( I have removed and replaced output modules ) if it can't communicate?
thanks