Good afternoon all,
I am attempting to get a panelview standard 1000e too communicate completely with a 1756-L83E through a 1756-DHRIO card and parts of the panel is communicating correctly with the block transfer. I've checked with hmi program to no avail and I have also tried to convert the block transfer bits to INT's from DINT's but it interferes with FBC and FAL instructions in the program. Sorry to ramble but my main question after consulting Knowledge-base is does anyone have input as to how to set up the FBC and FAL instructions? I feel as though this is what is in the way of complete communication. I have attached images of my studio 5000 program and the original PLC-5 program
Thank you very much
I am attempting to get a panelview standard 1000e too communicate completely with a 1756-L83E through a 1756-DHRIO card and parts of the panel is communicating correctly with the block transfer. I've checked with hmi program to no avail and I have also tried to convert the block transfer bits to INT's from DINT's but it interferes with FBC and FAL instructions in the program. Sorry to ramble but my main question after consulting Knowledge-base is does anyone have input as to how to set up the FBC and FAL instructions? I feel as though this is what is in the way of complete communication. I have attached images of my studio 5000 program and the original PLC-5 program
Thank you very much