peter.walker
Member
I have the need to change the program in an old Festo FPC202 plc.
The program is stored in an eprom which can not be programed via the PLC.
I have the software and cables to work with the program within the PLC ram, but would like to store permantly in the eprom.
Can anyone please explain how this is done, and what is required.
I recall a small stand alone eprom programmer being used connected to a pc.
Any further information on these PLCs would also be greatly apreciated.
I have tried many places for information on the Festo FPC202, but it has been long obsolete.
Thanks
Peter
The program is stored in an eprom which can not be programed via the PLC.
I have the software and cables to work with the program within the PLC ram, but would like to store permantly in the eprom.
Can anyone please explain how this is done, and what is required.
I recall a small stand alone eprom programmer being used connected to a pc.
Any further information on these PLCs would also be greatly apreciated.
I have tried many places for information on the Festo FPC202, but it has been long obsolete.
Thanks
Peter