Mike.McCance
Member
I am having an issue with communications on a PVPlus running v8.0 where I can run an application as a test app from my laptop connected to the same switch (unmanaged) as the PV is connected and all is well, can see the data change in the PLC (CLx L83) when I press buttons on the "HMI" in the test app. I then create the runtime and download and then nothing works. I checked the application settings in the PV and it all looks good, matches what I setup in the project.
Is there something I am missing? I haven't had to set up comms on these in a while and I do remember having some headaches with it in the past, but nothing I couldn't figure out on my own with some fiddling around, but I am stuck on this one.
Thanks,
Mike
Is there something I am missing? I haven't had to set up comms on these in a while and I do remember having some headaches with it in the past, but nothing I couldn't figure out on my own with some fiddling around, but I am stuck on this one.
Thanks,
Mike