GE FANUC PLC 4 sale

ronboom

Member
R
Join Date
Jul 2004
Location
Spring Lake, MI
Posts
22
Listing is attached. Will send photos if interested. Looking to get the cost of the software back -- $125 plus shipping for everything. I think the processor is bad. New Power Supply & a couple new I/O Modules. Got sick of trying to figure out what was wrong with it so I replaced it with a SLC 5/03. I've never programmed these before and this stuff is just setting in a box on a shelf.
 

Similar Topics

L
GE FANUC PLC Similator
Hi, hope you doing well I am looking for SIEMENS PLCSIM equivalent in GE FANUC PLC, RX3i PLC thank you
Replies
2
Views
55
loka9
L
S
What options for uploading from an old GE Fanuc Series One PLC?
Got an old machine with a IC610CPU104 CPU. A bit of research told me this is the same as DL305 so DirectSoft from AutomationDirect should work...
2
Replies
15
Views
2,173
strantor
S
A
PLC GE-Fanuc can Online Edit Program while CPU Run Time ?
Dear Everyone I work with PLC GE-Fanuc. But I don't know that "PLC GE-Fanuc (Series 90-30 and VersaMax) can Online Edit Programming while...
Replies
9
Views
3,139
alpine
A
U
GE Fanuc PLC programming
Our PLC output 7 opens a valve to move a cylinder rod. The output turns on every minute. The output is supposed to be ON for 10.56 seconds. But...
Replies
3
Views
2,943
Steve Bailey
Steve Bailey
W
GE Fanuc 90-30 PLC Software
Need to find where to get VersaPro or Proficy software for the GE Fanuc 90-30 PLC.
Replies
5
Views
2,575
geniusintraining
geniusintraining
Back
Top Bottom