fernandoguer
Member
Hey guys, I am fairly new to industrial communications. I recently got into a project in which I have a new Rx3I with a CMM002 module that I am trying to communicate with a maple systems HMI5150XL and a metasys integrator (as-mig-201-0). I want to use the modbus protocol to communicate between them, however, I am a little confused since the physical ports in the CMM002 are RJ45's. Is it possible to just run an RJ45 to rs232 adapter in order to communicate with those two pieces of equipment? Making the PLC act as a gateway between them (since the hmi wont be connected to the metasys integrator. Thanks everyone! I am eager to learn and any other advice would be greatly appreciated.