Getting LM90 to work w/DOSBox!

Maybe you can make the communications work if you use Windows XP Mode running in Windows Virtual PC??
This virtual PC running Windows XP is free from Microsoft.
 

Similar Topics

D
Getting connected to Allen Bradley Ultra3000
Hi how's it going. Was just wondering if someone could help me out. Recently one of the guys over on the LinuxCNC forums put me onto getting an...
2
Replies
15
Views
326
plvlce
P
N
Getting page fault exception error.
The application was working in Twincat 4022.16 Used VM for offline. recently changed the laptop and the getting the error with Message as below...
Replies
0
Views
84
Nag
N
N
WINCC SCADA getting this error
We are using wincc scada WinCC system software V7.5 SP2 , connected to few plc . Past 3 weeks we getting this alarm continously when we checked...
Replies
0
Views
115
Nimi4576
N
B
My college lab was getting cleared out and there was no place for this controllogix rack, so I was able to take it.
I am very, very new to PLCs. I only have experience with Picos, but I knew enough to save this from the dumpster. Apparently, everything on it is...
Replies
13
Views
711
geniusintraining
geniusintraining
E
FX3U clone problem getting analog input/output to work
Hi, I tried today to get RD3A and WR3A instructions to work on the PLC and it didn't work, but it worked in simulation. I followed the clone...
2
Replies
18
Views
1,515
parky
P
Back
Top Bottom