carlos1984
Member
Hi everyone, I know this is an old one but we have a d100 in our wrapper , it just stopped working. When the inputs are pressed the corresponding light does come on, but there is no out put light, Also the diagnostic ligts are all dark.
I was looking at the manual and it says that the battery cant be removed until the machine is off and the prom is backed up.
When it was being diagnosed the battery was disconnected and the machine was powered up while the battery was removed, could this have cause the ram to be deleted.
Since the diagnostic lights are not turning on we are wondering if the whole board is bad.
And if so does getting a new one fix the problem or would it have to be programmed too?
Lastly is there a company or person that can either fix these controllers or eve nupdate it to something new?
Any help or input is appriciated.
I was looking at the manual and it says that the battery cant be removed until the machine is off and the prom is backed up.
When it was being diagnosed the battery was disconnected and the machine was powered up while the battery was removed, could this have cause the ram to be deleted.
Since the diagnostic lights are not turning on we are wondering if the whole board is bad.
And if so does getting a new one fix the problem or would it have to be programmed too?
Lastly is there a company or person that can either fix these controllers or eve nupdate it to something new?
Any help or input is appriciated.