How to configuration 1794-IP4 in Control Logix over controlnet network?

pratap_awate

Member
P
Join Date
Jan 2010
Location
Pune
Posts
1
Hello,
I have Control Logix 1756-L63 processor with 1756-CNB module.
On controlnet network there is Flex frequency counter 1794-IP4 module through adapter 1794-ACN15.

Can any one guideline me how to configure this module using RSLogix5000 Ver 16.00.

I have tried 'MSG' instruction to Block transfer Read and Write. In Message Configuration, Communication tab, i have checked to ControlNet, also given path for 1794-IP4.

But it didn't communicate with IP4 module, show Extended Error Code 16#0000_0114 means 'Wrong Module'.

I really need help on this.
 

Similar Topics

M
1794-ADN configuration
I have to configure new 1794-ADN Series C in my devicenet network. I have downloaded the EDS File and registered it. But while configuration in...
Replies
3
Views
1,055
Ken Roach
Ken Roach
J
1794-IR8 Configuration
Hello everyone. I have installed a remote Flex i/o enclosure with a AENTR ethernet adapter and an 1794-IR8 RTD card. I have landed 4 RtdÂ’s on...
Replies
0
Views
803
Jameswhi
J
D
configuration of 1794 IE8 analog input card.
Hello everybody, I am using SLC 5/05 processor. and used with 1747- SN RIO Scanner. and used 1794 ASB adapter. used 8...
Replies
0
Views
7,028
dpatel
D
A
Kinetik 300 -2097-V33PR3 Master and Slave Configuration
Hi i using Kinetik 300 2097 driver control by EIP with using move absolute and incremental for motion , but i want to add same driver and motor as...
Replies
0
Views
55
Ansonkiek
A
A
45DMS-B8LAT1-D4 configuration
Hello I have a sensor that I read data with IO-LINK but I don't know how to get my data. I see that I have two modes : Process data Map0 and Map...
Replies
0
Views
61
ahmeduqat
A
Back
Top Bottom