Aljubovic
Member
So I installed advanced hmi and grabbed an ethernet cable. I have the click C0-12DRE-1-D PLC.
I installed the advanced hmi and added the modbusTCP driver. I then went and opened the click programming software and found the ip for my click. I entered it in then I added a digital panel meter. I went into my click plc and found a simulation value that I wanted to display. I copied the modbus address and inputted it.
I also have a Ea9 hmi connected to port 2 on the click PLC. I use this is control the simulation.
I connected the ethernet port to my pc and started the program, nothing is displaying on advanced hmi, my ea9 hmi is displaying the value normally.
Am I doing something wrong? How do you find out what is your Click PLC's IP address? Can I not connect an pc to the ethernet port 1 and an hmi in port 2?
Where do I find the constant value of the clicks IP address?
I installed the advanced hmi and added the modbusTCP driver. I then went and opened the click programming software and found the ip for my click. I entered it in then I added a digital panel meter. I went into my click plc and found a simulation value that I wanted to display. I copied the modbus address and inputted it.
I also have a Ea9 hmi connected to port 2 on the click PLC. I use this is control the simulation.
I connected the ethernet port to my pc and started the program, nothing is displaying on advanced hmi, my ea9 hmi is displaying the value normally.
Am I doing something wrong? How do you find out what is your Click PLC's IP address? Can I not connect an pc to the ethernet port 1 and an hmi in port 2?
Where do I find the constant value of the clicks IP address?
Last edited: