how to connect fx2n and E 500 inverter via Rs 485

nadeemalik

Member
N
Join Date
May 2011
Location
pakistam
Posts
6
hi
i m new in plc programming.
i want to connect the fx2n plc with fr-e 500 inverter via rs 485.
i have searched a lot on internet but could find a good example.
i m using a Fx 485 BD card on Fx2nc plc.
i want to know what registers are involved in doing this.
my goal is to send frequency ref and run command of inverter from plc via rs 485.

plz reply
 

Similar Topics

G
Whats theasyest way to get the FX2n and FX3u plcs to connect to a network
Yup they don't have any Ethernet posts on them but would like to try and see if I can get them to connect to a network to get certain info on the...
Replies
8
Views
2,424
Greg7683
G
A
e300 connect to FX2N
hi dear in E300 PROG/SETUP is deasabled by command line. now how can i enable it again?also is any setting to connect a new E300 to FX?
Replies
0
Views
1,501
allahdini
A
H
Swapped old fx2n for fx3u won't connect.
Hello to all, I recently changed out our fx2n with an fx3u and now unable to connect, I did change the setting in the program with the new plc...
Replies
1
Views
2,398
hotrod
H
K
Configuring Stratix 5400 to connect to a Stratix 5700
Greetings, I had an issue with a RIO rack 2 and IFM I/O Link dropping on my network. I would loose connection for a second or 2 then they would...
Replies
3
Views
104
harryting
H
Suhail
help me out to connect lenze i700 to PC
Hi friends, i need a help to know the procedure and steps to connect Lenze i700 to PC for parameterize. i tried with lenze easy-starter using LAN...
Replies
0
Views
58
Suhail
Suhail
Back
Top Bottom