I am using an ultrasonic sensor to measure distance and the input is not too stable. I know this is the nature of the sensor,ambient conditions and so forth. I am using a Banner U-Gage T30. What I would like to do is take an average of 5 to 10 samples and throw out the hi and low values. I am having a hard time figuring this out without walking on my data and making it unusable. I am using a Horner PLC with 12 bit analog resolution.
I need to control the inflation of a sample and maintain an inflation rate of 22mm/Min. This is per ASTM 5617, multiaxial burst test. I will adjust the I/P based on the inflation rate that I see. Any suggestions?
I need to control the inflation of a sample and maintain an inflation rate of 22mm/Min. This is per ASTM 5617, multiaxial burst test. I will adjust the I/P based on the inflation rate that I see. Any suggestions?